Towards the synthesis of MAX-phase functional coatings by pulsed laser deposition

Pulsed laser deposition with a Nd:YAG laser was used to grow thin films from a pre-synthesized Ti₃SiC₂ MAX-phase formulated ablation target on oxidized Si(1 0 0) and MgO(1 0 0) substrates. The depositions were carried out in a substrate temperature range from 300 to 900 K, and the pressure in the deposition chamber ranged from vacuum (10⁻⁵ Pa) to 0.05 Pa Argon background pressure. The properties of the films have been investigated by Rutherford backscattering spectrometry for film thickness and stoichiometric composition and X-ray diffraction for the crystallinity of the films. The silicon content of the films varied with the energy density of the laser beam. To suppress especially the silicon re-sputtering from the substrate, the energy of the incoming particles must be below a threshold of 20 eV. Therefore, the energy density of the laser beam must not be too high. At constant deposition energy density the film thickness depends strongly on the background pressure. The X-ray diffraction measurements show patterns that are typical of amorphous films, i.e. no Ti₃SiC₂ related reflections were found. Only a very weak TiC(2 0 0) reflection was seen, indicating the presence of a small amount of crystalline TiC.     

用AT89C51单片机和MAX505 DAC研制的程控信号源

本文介绍了用单片机AT89C51和MAX505 DAC制作程控信号源的原理,并在其中对AT89C51单片机和MAX505 DAC的工作原理及特性,怎样用单片机的中断控制和串行接口控制作为重点给予了阐述。     

SPE电极上Pt单组分及Pt-Au双组分还原态CO_2阳极剥离电化学氧化行为研究

采用循环伏安法，对ＳＰＥＰｔ电极以及ＳＰＥＡｕ－Ｐｔ电极上还原态ＣＯ２的电化学氧化行为研究表明，此类电极的电化学特性与光滑Ｐｔ电极一致：ＣＯ２在氢原子吸附电位区０～２５０ｍＶ（ｖｓ．ＲＨＥ）处，可与电极上化学吸附的氢反应，生成还原态的ＣＯ２，通过线性扫描，还原态ＣＯ２即发生一不可逆电化学氧化过程（阳极剥离）．在ＳＰＥＰｔ系列及ＳＰＥＡｕ－Ｐｔ系列上ＣＯ２的电化学行为表明，当ＳＰＥＰｔ系列上Ｐｔ的载量为２．５ｍＬ的０．０１ｍｏｌ·Ｌ－１Ｈ２ＰｔＣｌ６的Ｐｔ时，对还原态ＣＯ２的电催化活性最好，当Ｐｔ的载量相同时，在ＳＰＥＡｕ－Ｐｔ上，催化剂对还原态ＣＯ２的电化学氧化行为比ＳＰＥＰｔ电极更强，这是由于预先沉积的Ａｕ对后沉积的Ｐｔ有调制作用．     

金属-有机骨架MIL-101(Cr)掺杂聚合物整体柱的制备及其用于酚类化合物的在线固相萃取

制备了金属-有机骨架（MOF）MIL-101（Cr）掺杂聚合物整体柱，建立了在线固相萃取-高效液相色谱检测水中4-硝基苯酚、2-硝基苯酚、3-甲基苯酚和2，4-二氯苯酚的方法。考察了样品溶液pH值、上样时间、上样流速和解吸时间对酚类化合物萃取效果的影响。在最优萃取条件下，采用制备的整体柱检测水中酚类化合物，其富集因子高，线性范围宽，精密度好，检出限低，适用于水中酚类化合物的检测。制备掺杂聚合物整体柱是促进和拓宽MOFs在线固相萃取应用的有效方法之一。     

高效液相色谱-串联质谱法同时测定表层水体中5类40种抗生素

建立了固相萃取-高效液相色谱-串联质谱（SPE-HPLC-MS/MS）同时检测表层水中5类40种抗生素的分析方法。水样经过滤、固相萃取柱富集净化后，以乙腈-0.2%（v/v）甲酸水溶液为流动相进行梯度洗脱，采用电喷雾电离源，在多反应监测、正离子模式进行定性定量分析。结果显示，40种抗生素在1~200 μg/L水平下线性关系良好，平均加标回收率为41.3%~112.6%。采用该方法对长江南京段表层水体进行检测，共检出13种抗生素，含量为13.4~780.5 ng/L，其中喹诺酮类抗生素恩诺沙星检出率达100%，大环内酯类抗生素克林霉素最高检出水平达739.4 ng/L。该法高效、灵敏、可靠，可用于实际水样中多种抗生素的分析。     

Preconcentration of copper with multi-walled carbon nanotubes pretreated by potassium permanganate cartridge for solid phase extraction prior to flame atomic absorption spectrometry

A procedure for the preconcentration of copper was described in this paper using multi-walled carbon nanotubes (MWCNTs) oxidized by potassium permanganate as the adsorbent for the enrichment of trace copper in water samples. Important parameters, such as the sample pH, the concentration and volume of eluent, sample flow rate and volume, and interference of coexisting ions, were investigated. The obtained results indicated that proposed method possessed an excellent analytical performance. The linear range, the detection limit, and precison (RSD) were 1-100 ng/mL (R2 = 0.9993), 0.32 ng/mL and 2.88%, respectively. The results showed that copper could be adsorbed quantitatively on the pretreated MWCNTs with potassium permanganate, and proposed method was very useful in the monitoring of copper in the environment.     

Pt immobilized spontaneously on porous MXene/MAX hybrid monolith for hydrogen evolution reaction

Designing efficient electrocatalysts with low Pt loadings for hydrogen evolution reaction(HER) is urgently required for renewable and sustainable energy conversion.Here,we report a strategy that Pt nanoparticulates are spontaneously immobilized on porous MXene/MAX monolith as HER catalysts by utilizing the redox reaction between Ti_3C_2T_x MXene and [PtCl_4]~2 in H_2 PtCl_6 aqueous solution.By taking advantage of homogeneously distributed Pt nanoparticulates on highly electrically conductive porous Ti_3C_2T_x/Ti_3AlC_2 monolith,the as-prepared electrocatalysts show high catalytic performance for hydrogen evolution.Specifically,the binder-free electrocatalysts have Pt loadings as low as 8.9 μg/cm~2,with low overpotential of 43 mV at a curre nt density of 10 mA/cm~2 and low Tafel slope that three times lower than porous Ti_3C_2T_x/Ti_3AlC_2 without Pt loading.This strategy offers a new approach to constructing ultra-low Pt-loading HER catalysts on the basis of in situ redox reaction between noble metal ions and MXenes.     

Optimization and validation of an enzyme immunoassay for the insect growth regulator fenoxycarb

A competitive enzyme-linked immunosorbent assay (ELISA) was developed for the quantitative detection of the insect growth regulator fenoxycarb. Polyclonal rabbit antisera, raised against protein conjugates of four haptenic derivatives of fenoxycarb, were utilized in immobilized antigen-based, competitive immunoassays. With ELISA systems that were both hapten- and carrier-heterologous, most antiserum titers fell in the range of 1:1000-1:30,000. Assay conditions, including concentrations of antisera and coating antigens, were optimized. The effect of pH, organic solvents, and various blocking agents was also investigated. A hapten-homologous and two hapten-heterologous indirect ELISAs allowed fenoxycarb determination in the range of 0.1-85 ng ml⁻¹ with apparent IC₅₀ values of 1.2-2.8 ng ml⁻¹. Cross-reactivities with a number of compounds (e.g. pesticides of related structure, hapten synthesis intermediates, fenoxycarb metabolite, photodegradation products) were determined, and the assay proved highly selective for fenoxycarb. In particular, no significant interference was found with selected pyrethroid and juvenile hormone analog insecticides, phenoxyacetic acid herbicides, and photodegradation products of fenoxycarb. Using spiked water samples, assay performance was validated by SPME/GC-MS.     

Development of an HPLC method with electrochemical detection of femtomoles of 8-oxo-7,8-dihydroguanine and 8-oxo-7,8-dihydro-2'-deoxyguanosine in the presence of uric acid

A selective method based on high performance liquid chromatography with electrochemical detection (HPLC-ECD) was developed to enable simultaneous detection of 8-oxo-7,8-dihydroguanine (8-oxoGua) and 8-oxo-7,8-dihydro-2′-deoxyguanosine (8-oxodGuo), products of DNA oxidative damage, in the presence of uric acid (UA), a strong interferent in their electrochemical detection. The method developed consists of HPLC isocratic elution with amperometric detection on a glassy carbon electrode, enabling a detection limit for 8-oxoGua and 8-oxodGuo lower than 1 nM in standard mixtures. Detection of low concentrations up to 25 nM of 8-oxoGua and 8-oxodGuo in the presence of UA in a 10⁴-fold higher concentration was achieved after one-step solid phase extraction (SPE). The method was tested with urine samples and it was possible to detect and quantify the presence of 8-oxoGua, and to confirm that UA was eliminated after uricase degradation and SPE. The LOD found in urine samples was about 80 nM, a value higher than in standard mixtures, due to the increase of background current in the urine matrix. The results presented here contribute to the development of a methodological approach to simultaneous determination of 8-oxoGua and 8-oxodGuo in urine samples.     

Solid-phase extraction of iron(III) with an ion-imprinted functionalized silica gel sorbent prepared by a surface imprinting technique

A new Fe(III)-imprinted amino-functionalized silica gel sorbent was prepared by a surface imprinting technique for selective solid-phase extraction (SPE) of Fe(III) prior to its determination by inductively coupled plasma atomic emission spectrometry (ICP-AES). Compared with non-imprinted polymer particles, the ion-imprinted polymers (IIPs) had higher selectivity and adsorption capacity for Fe(III). The maximum static adsorption capacity of the ion-imprinted and non-imprinted sorbent for Fe(III) was 25.21 and 5.10 mg g⁻¹, respectively. The largest selectivity coefficient of the Fe(III)-imprinted sorbent for Fe(III) in the presence of Cr(III) was over 450. The relatively selective factor (α_r) values of Fe(III)/Cr(III) were 49.9 and 42.4, which were greater than 1. The distribution ratio (D) values of Fe(III)-imprinted polymers for Fe(III) were greatly larger than that for Cr(III). The detection limit (3σ) was 0.34 μg L⁻¹. The relative standard deviation of the method was 1.50% for eight replicate determinations. The method was validated by analyzing two certified reference materials (GBW 08301 and GBW 08303), the results obtained is in good agreement with standard values. The developed method was also successfully applied to the determination of trace iron in plants and water samples with satisfactory results.